2005-2014 Ford Mustang S197 KellTrack Rear Spring Spacer Kit, ADJUSTABLE

These spacers mount on top of your axle, below the rear coil springs to raise the vehicle from approximately 1/8" up to about 1/2" depending on how you configure them. This kit provides you with a stock style higher durometer rubber isolator replacement and a pair of "nylon carbon" 1/4" spring spacers. 

This spring spacer method is most commonly needed when people use a lowering drag spring in search of a softer spring rate - but need to raise the car for better tire clearance and alignment characteristics. 

1: Replace the OE isolator with ours, gain approximately 0.125" rise

2: Install our spacer over your worn OE isolator for approximately 0.250" rise

3: Replace the OE isolator with ours, relocate the OE worn isolator to the TOP over the cone for 0.300" rise 

4: Replace the OE isolator with ours, use our provided spacer on top or bottom for approximately 0.375" rise

5: Install our isolator and our spacer onto your existing setup without removing anything OE, for approximately 0.500" rise