These BMR Handling Lowering Springs are specifically designed for use on 2015 to 2025 GT Mustang Coupes or Convertibles equipped with independent rear suspension (IRS). Not intended for use on V6 or EcoBoost models.
BMR Suspension designed their Handling Lowering Springs with autocross and road course applications in mind. Featuring a linear spring rate these BMR Handling Lowering Springs will lower your S550/S650 Mustang's center of gravity, reduce squat during acceleration, body roll in the corners and excessive nose-dive under hard braking. BMR Handling Springs feature a fine-tuned spring rate to give you the ultimate in handling performance.
Not only does a set of BMR Springs improve the handling performance of your Mustang, but they also improve its overall appearance. By lowering the ride height approximately 1.2" up front and 0.5" in the rear these BMR Performance springs will eliminate that huge tire to fender gap, for a sleek muscle car stance.
Designed and manufactured in the USA, these BMR Lowering Springs are CNC cold wound from chrome silicon high-tensile spring wire. To guarantee that their springs will not sag over time, BMR fully compresses every spring twice to permanently set the spring. To eliminate the stresses induced during the winding process BMR springs are stress-relieved at 750 degrees F. Shot-peening is then used to eliminate any residual surface stresses. As the final step every spring is compressed and tested allowing BMR to offer a Lifetime Warranty against spring sag.
BMR Handling Lowering Springs are available as a pair of two Front Springs, a pair of Two rear Springs or as a complete set of four. Please select from the options listed above.